Home / Our Products /
Air Quality Products / Duct Mounted Ozone Generator
Duct Mounted Ozone Generator
We offer a state-of-the-art duct mounted ozone
generators with parallel tube type ozone modules. This equipment is based on
the latest technology of power conversion on higher frequency, with the use
of this technology, the welding transformer and chargers size become
miniature and the most relaible technique being used in the Air Quality
Management Systems.
Duct Mounted Ozone Generator
The technolgy consists of parallel tube type
corona system which works on a high frequency (from 7 to 9 KHz). The
discharge takes place between the two Quartz tubes, which is located
parallel to each other. This Ozone Generating Unit is installed inside the
duct and the oxygen of the air passes through the duct and gets converted
into Ozone. After which the ozonated air gets mixed with the total air
stream. The operating area in the air stream is quite low and thus does not
offer any restriction to flow of air in the duct. This offers various
advantages like operation and maintainence friendly, better ozone output
control, consistent and very long life.
Features
Ozone generator is compact, self
contained unit suitable for duct mounting
Components in air stream are made
up of stainless steel frame of 18 G
The construction allows adequate
flow of air over the corona discharge tubes surface
Ozone will be produced by the
principle of corona discharge using parallel tube type corona unit
The ferrite core transformer is
used in the ozone generator for efficient & long lasting operation
The parallel tubes will be mounted
on H.T. Transformer
Due to the construction and M.O.C
selected for parallel tubes are anti-statically charged
Not allow any dust to settle on to
the surface
Ozone generators have a high
frequency inverter to convert 50 Hz input supply to 20 K Hz Stepped upto
6-9 KV to be applied across parallel tube
Ozone generators permit easy
withdrawals and refitting in the duct due to light weight and easy
construction
Ozone coming out from the unit
will be mixed with total air stream
The life of the tube type corona
generators is much higher than other type of ozone generation systems
The corona tubes repels the
accumulation of the dust and formation of sediments by tar, nicotine and
grease
Improve the operational
reliability and ease of maintenance
The generators will operate with
airflow in either direction with same efficiency
All parts and components of the
generator will be fire retardant
Generator output will be suitable
for modulation by automatic or manual controls
The generator will be rated for
operation on 0 to 95% RH (without condensing moisture)
The generator will be suitable for
operation on electrical supply 220V to 240 Volts, single phase, 50 Hz, 3
wire systems
System
The system is engineered to provide residual
Ozone concentration not exceeding the prescribed limits i.e. 0.03 PPM. These
generators are manufacter in such a manner to ensure the VOC are kept below
the TLV(Thereshold Limit Value) for occupied areas as recommended by ASHARE
& OSHA . The rate of variation of production of Ozone will follow the
rate of variation of VOC in the indoor environment.This is in view to ensure
residual level of Ozone in the indoor environment remain low while ensuring
residual VOC level also remains low. The transformer is encapsulated with
epoxy. Epoxy is penetrating into windings and around the core
Duct Injectible Ozonation System
To have a better control of Ozone concentration
in the Duct, Injectible Ozonation Systems are utilized. Ozone Generator is
located closed to the duct and Ozone is fed by a pipe & diffuser inside
the Air Duct. Ozonator gets feed air from a centralized Unit. The quantity
of Ozone to be injected in the duct, depends upon the final Ozone
concentration at the destination locations. Ozone concentration is monitored
and signal is provided for fed back control.
These Systems are used in Food Processing
Companies, Cold Storages, Hospitals, STPs, ETPs and critical locations where
the Ozone concentration is required to be controlled irrespective of air
quality and quantity in the air duct.
Ozone System can be controlled from a remote location and integrated with
Plant Automation System, PLC or SCADA.
Standalone Ozonation Systems
We have wide variety of Stand Alone Ozonation
Systems which are either mounted on the wall or can be portable with wheels.
The Ozonation Systems can be controlled from the Panel or from wireless
Remote. The Stand Alone Ozonation Systems are utilized for maintaining the
requisite Ozone concentration at a specific location where either the
air-conditioning is not existing or in case of central air-conditioning,
specific location is required to be treated by Ozone for sterilization or
deodorization.
The Stand Alone Units are available from very
low to higher capacity and can be tailor made with timers or sequential
operation as per specific requirement of the client or the process.
Manufacturer of
Ozone Generators, Ozone Monitors & Controllers, Ozone Accessories,
Ozonation Systems
having a rich experience in the field of Ozone and Ozone Applications